Graco LineDriver, Операция, ремонт и запасные части.

Страница: 21 / 64

Troubleshooting
21
Troubleshooting
PROBLEM CAUSE SOLUTION
Engine does not start Parking brake not engaged. Engine
switch OFF, no gasoline or low oil
Set Brake. Consult engine manual,
supplied
Engine races to high rpm - stalls during
operation
Worn governor Consult engine manual, supplied
Engine operates, LineDriver does not
move forward or reverse
Low hydraulic oil
Wheel release is open. Fill hydraulic reservoir with Mobil 1
(15W-50) synthetic oil
Close; hand tight.
Engine operates, LineDriver moves
slowly in forward and reverse
Low hydraulic oil. Parking brake is set.
Wheel release is open. Fill with Mobil 1 (15W-50) synthetic oil.
Release parking brake.
Close; hand tight.
Engine shuts off when operator exits
LineDriver
Safety switch Set parking brake
Engine continues to run when operator
exits LineDriver and parking brake is not
set
Safety switch Adjust and set parking brake. Replace
safety switch and/or any connecting
wires.
Engine misses during turns and forward
and reverse changes
Engine oil low
1. Consult engine manual for proper oil
2. Keep engine oil full to avoid
nuisance stalls caused by Oil Alert
sensing low oil levels.
Parking brake does not keep LineDriver
from moving
Parking brake needs adjustment Adjust parking brake
LineDriver creeps in forward or reverse
direction
Parking brake needs adjustment Adjust parking brake
Engine light does not turn on Check light bulb Replace light bulb
Check connections Repair connections
Check Switch position on regulator Set Switch position on regulator:
1. Set to No Battery if your LineDriver
has no battery
2. Set to Battery if your LineDriver has
a battery
Engine runs for short time and stops Fuel flow restriction See engine manual