Electrical
Electrical
Electrical Connections
Connections
Connections
NOTICE
NOTICE
NOTICE
To avoid electrical component damage, remove all
system power before plugging any connectors.
NOTE:
NOTE:
NOTE: See the
Electrical Schematics, page 24
1.
Verify that electrical power is removed from the
system.
2.
Remove the cover from the PD2K/PD1K
electrical control box.
3.
Remove the knockout (K) from the side of the
electrical control box.
4.
Thread the cable into the electrical control box
and connect to the appropriate connection port
on the enhanced fluid control module. For
example, connect Pump 1 to P1 and Pump 2 to
P2 (PD1K only); Pump 3 to P3, Pump 4 to P4,
and so on.
Figure 8 Install Grommet in Electrical Control
Box
Figure 9 Enhanced Fluid Control Module
Connection Points
16
332456D
