Repair
36
311075ZAB
Repair
Before Beginning Repair
1. Flush the system if possible. See
, page
28. If not possible, clean all parts with solvent
immediately after removal, to prevent isocyanate
from crystallizing due to moisture in the
atmosphere.
2. Set the function knob to Park
.
3. Shut off Motor Power. Disconnect the power supply.
4. Shut off the Heater Power. Allow the equipment to
cool before repairing.
5. Follow the
, page 22.
Remove Supply Tanks
Refer to your displacement pump manual for repair and
parts information.
1. Follow
2. Follow the
3. Close both fluid inlet ball valves (52).
NOTE:
Use dropcloth or rags to protect Reactor E-10
and surrounding area from spills.
4. Open the filter drain plug on Y-strainer (51).
5. Disconnect the swivel elbow (50) at the pump fluid
inlet.
6. Remove the screws (4) holding the tank to the cart
frame.
7. Pivot the top of the tank to the side and lift it and the
fluid inlet fittings off of the cart.
Repairing this equipment requires access to parts
which may cause electric shock or other serious injury
if work is not performed properly. Be sure to shut off
all power to the equipment before repairing
52
50
51
