Operation
24
311075ZAB
•
For a quicker start, do initial heatup circulation with
the tanks 1/4 to 1/3 filled, then add more material.
Heating Foam Resins with 245 fa
Blowing Agents
New foam blowing agents will froth at temperatures
above 90°F (33°C) when not under pressure, especially
if agitated.
Never
fill the 7 gal. (26 l) supply tanks beyond the 5 gal.
(19 l) line on the tanks, to leave room for some frothing.
At High Ambient Temperature (above
75°F/24°C)
•
Pour resins slowly to avoid frothing.
•
Only use Slow Recirc
, to avoid heating and
agitating the tank. If temperature doesn’t keep up,
set the function knob to Park
, then set to Slow
Recirc
again.
•
When you stop to refill the tanks, avoid boiling off
fluid in the heaters by following these steps:
a. Shut off Heater Power.
b. Leave the hoses under pressure.
c.
d. Set the Spray valves to Recirc.
e. Set the function knob to Slow Recirc
.
f.
Turn on Heater Power.
At Cool Ambient Temperature (below
75°F/24°C)
•
Use Fast Recirc
to heat the tanks to 75-90°F.
(24-32°C), then use Slow Recirc
to raise the
hose and gun to desired spray temperature.
•
If the top of the resin in tank starts frothing, do not
use Fast Recirc
any more.
