5
308069
Installation
Prepare for installation
You must supply the following equipment to complete
the installation of this system.
1.
An adjustable wrench and a screwdriver.
2.
A grounding wire and clamp for the air motor.
3.
The compressed air supply, with a hose that easily
reaches the air regulator assembly.
4.
Two 5 gallon flushing containers, one with warm
soapy water, and one with cool, clean water.
CAUTION
Do not use paint solvents to flush, which will damage
the pump seals.
Setup for initial flushing
See Fig. 3.
5.
Screw the air regulator assembly into the air inlet
of the motor.
6.
Remove the quick disconnect coupler from the
nipple. To disconnect, pull back on the sleeve of
the coupler and pull it away from the nipple. Screw
the coupler onto the air line. Do not connect the air
line to the pump until you are instructed to in the
Initial flushing or OPERATION section.
7.
Screw the swivel fitting of the spray hose onto the
pump outlet nipple, and tighten it securely with a
wrench.
8.
Follow the grounding instructions in the Ground-
ing section on page 4.
