10
308069
Operation
Installing the spray tip
1.
Be sure the trigger safety latch is engaged.
2.
Install the tip cylinder. Hold the cylinder with the
arrow handle straight up. Push the cylinder into the
tip guard so the flange on the cylinder fits into the
slots at the base of the tip guard. See Fig 7. Then
turn the arrow handle in the direction of the tip
guard, which is the spraying position. See Fig. 8.
If the tip guard was removed from the gun and
you are are reinstalling it:
3.
Be sure the seal and square ring are in place as
shown in Fig. 7. If not, place the seal on the end of
a pencil with the curved side out. Guide the seal
into the retaining nut and turn it until it straddles
the cylinder. Drop in the square ring and press it
down.
4.
Screw the retaining nut snugly onto the gun,
holding the tip guard in the desired direction while
tightening the nut. See Step 4 of
Adjusting the
spray pattern and spraying pressure on
page 12
for more information on adjusting the
direction of the spray pattern.
CAUTION
To avoid damaging the tip guard:
D
Never use a wrench to turn the plastic tip guard,
which causes internal damage.
D
Never hang the gun by the tip guard.
Fig. 7
TIP GUARD
TIP CYLINDER
ARROW HANDLE
RETAINING NUT
SEAL
SQUARE RING
FLANGE
curved side faces retaining nut
SLOT
TIP SIZE MARKED HERE