11
308069
Operation
Changing spray tips
WARNING
To reduce the risk of serious injury whenever you
are instructed to relieve pressure, always follow the
Pressure Relief Procedure on page 8.
Relieve the pressure. Rotate the arrow handle until it
is straight up. Pull out the tip. Install the new tip and
rotate it to the spraying position.
Clearing a clogged spray tip
WARNING
To reduce the risk of serious injury from fluid injec-
tion, use extreme caution when cleaning or chang-
ing spray tips. If the spray tip clogs while spraying,
set the trigger safety latch immediately, then follow
the procedure in Steps 1–5 at right.
Never wipe off buildup around the spray tip until
pressure is fully relieved and the trigger safety latch
is set.
Fig. 8
ARROW HANDLE
SHOWN IN THE
TIP CLEARING POSITION
ARROW HANDLE
SHOWN IN THE
SPRAYING POSITION
Rotate handle up and
toward back of the gun
then trigger the gun to
clear an obstruction.
7555A
7554A
1.
If the spray tip clogs, release the gun trigger, and
set the trigger safety latch.
2.
Turn the arrow handle up and back toward the gun
body. See Fig. 8. Release the trigger safety latch.
Trigger the gun into a pail. This usually forces out
the obstruction. Set the trigger safety latch again.
Return the arrow handle to the spraying position.
3.
Release the trigger safety latch and resume spray-
ing.
4.
If the tip is still clogged, close the air regulator,
disconnect the air line, try triggering the gun into a
pail, and open the drain valve.
5.
Remove the spray tip and clean it. Refer to manual
307848, supplied.
NOTE: Continue with Adjust the spray pattern and
spraying pressure on page 12.
