grace design m906
owner’s manual
17
y
5.1 CR OUT 2 (balanced via female DB-25 connector)
y
Stereo CR OUT 1 (balanced via two male XLR connectors wired pin 2 hot, pin 3 cold and pin 1 ground)
y
Stereo CR OUT 2 (balanced via two male XLR connectors wired pin 2 hot, pin 3 cold and pin 1 ground)
y
Optionally, a third stereo pair via CUE OUT (balanced via two male XLR connectors wired pin 2 hot, pin 3 cold and pin
1 ground)
The SPKR SEL switch, located directly above the TALKBACK switch, is used to cycle between available
speaker output sets. The configuration of the speaker output set used is based on the current input
selected, i.e. if you have a 5.1 input source selected, this audio will be routed out via one of the two
available 5.1 control room outputs. If you have a stereo input source, this will be routed to the left and
right Control Room output XLRs, as well as the left and right connections on a DB-25 Control Room
output. Similarly, with a 5.1 source, left and right will be present on both the XLRs and the DB-25s.
The currently selected output set number is indicated by illuminating the relevant LED to the left of
the SPKR SEL switch. To toggle through the available output sets, simply press the SPKR SEL switch. For
example, if speaker output number 1 is currently active, pressing the SPKR SEL switch will change this
to speaker output number 2. Pressing the switch again will toggle the selection back to speaker output
number 1.
USinG mon > cUe (SPkR 3) aS a tHiRD SteReo SPeakeR oUtPUt
In most situations, having access to two sets of stereo control room outputs will be adequate. This will
allow, for instance, CR OUT 1 to feed your main stereo monitors and CR OUT 2 to feed a near-field pair.
However, if you find yourself in need of a third stereo monitoring configuration, here’s how to proceed:
To activate the MON > CUE switch as a control for routing audio to a third set of stereo speakers, do the
following:
y
Press the CAL switch. The switch LED will begin to flash, letting you know that CAL mode is now active.
y
Press the MON > CUE switch. The LCD display will indicate whether you are in MON > CUE mode or in Speaker #3
mode (screenshots 3 & 4).
cue mode, global level
screenshot 3
speaker 3 mode, global offset
screenshot 4
y
Press the MON > CUE switch one more time to activate this special mode.
y
Exit CAL mode by pressing the flashing CAL switch.
The MON > CUE switch has now been configured to select a third speaker output set.
Note: the physical
