Gotting HG G-19370ZA, Руководство пользователя

Страница: 11 / 30

Device Description HG G-19370ZA | English, Revision 01 | Date: 17.05.2017 | www.goetting-agv.com
11 Chapter 3: Mounting HG G-19370ZA
3.2.2 Mounting on the Vehicle
Figure 3
Casing dimensions and mounting drill holes
The inductive guidance sensor has two drill holes with a diameter of 5.3 mm each with
which it can be mounted by putting screws through the holes. The drill holes have a dis-
tance of 140 mm to each other (center of hole <—> center of hole). The magnet sensor is
to be mounted diagonally to the direction of travel with the connectors facing upwards (first
sketch in Figure 3 above). The recommended reading height is 60 to 200 mm from the bot-
tom edge of the casing to the guide wire.
Figure 4
Possible mounting position for the inductive guidance sensor
Direction
of travel
Lower edge
of the device
ST1 CAN 1 CAN 2
M12 x 1 circular connector
8 pin (male, A coded)
M12 x 1 circular connector
5 pin (female, A coded) M12 x 1 circular connector
5 pin (female, A coded)
Mounting drill holes
Direction of travel
Guide wire
Vehicle
Top
Road surface
Mounting the
sensor backside
to the vehicle
Reading height
above guide wire