The Analogue Filters Pages
Anamono has 2 analogue filters connected in parallel to each other. Each filter can be adjusted and
controlled separately. In this one section, you make the adjustments for both filters.
One of the analogue filters has selectable mode – lowpass, bandpass, highpass or off, while the
other filter are always in bandpass mode.
A filter shapes the sound, by removing certain harmonics from the source audio signal, and by
amplifying certain harmonics around the cutoff frequency point (using resonance).
Edit 1 – DSP filter output level:
Value: 0 to 255. If connection = serial: Adjusts the level of the
DSP filter, going to the analogue filters input. If connection = parallel, feed or gran: Adjusts the
output level of the DSP filter.
Edit 2 – External audio input level:
Value 0 to 255. Adjusts the level of the audio signal present
on the external audio input, going to the analogue filters inputs.
Encoder – DSP filter connection:
Values:
-ser:
In serial connection with the analogue filters.
-par:
In parallel connection with the analogue filters.
-fed:
Placed inside the g-RAY feedback loop.
-grn:
Placed after the granulator/delay.
6 ANALOG FILTERS
1 Dflt . Inp. Conn
X 88 0 ser
