Instructions for use and installation
5
1 2 3 4 5 6 7
1
Gas ignition device button (certain models only)
2
Cooking zone, rear left, normal burner
3
Cooking zone, front left, normal burner
4
Oven illumination switch (certain models only)
5
Oven function mode selection and temperature
selection button
6
Cooking zone, front right, large burner
7
Cooking zone, rear right, auxiliary burner
Electric ignition
(certain models only)
Gas burners may be ignited with the electric ignition device,
built-in adjacent to each burner.
The gas starts coming out when you push the cooking zone
control button, and is ignited by pushing the ignition device
button.
Electric ignition will operate only if the mains lead is plugged
into the mains socket.
In case of electric failure or damp ignition device, both the
cooktop burners or oven burner may be ignited with a simple
match or lighter.
Gas burner control
Cooking burners are controlled by the relevant control knobs.
Heating power is indicated on the knobs by the large flame
symbol and the small flame symbol.
Always turn the knob over the large flame position towards the
small flame position and back. The operating position is always
between the two flame symbols.
Safety cautions in regard to the cooking zones
•
Never use cooking zones without dishes, or for heating the
ambience!
•
Keep the cooktop clean, since dirt and stains have adversary
effect on the functionality of burners.
•
If you like your food to be crisp, first set the burner to the
maximum and continue cooking at minimum power.
•
Always provide adequate quantity of water when cooking in
the pressure cooker. Lack of water may cause damage to
the dish and to the cooker.
•
Cooktop burners are thermally protected. If the burner
flame is accidentally extinguished (spilled food, gust of
wind) the gas supply is automatically shut. There is no
possibility of gas escaping into the room!
•
If the flame of thermally non-protected cooking burners
is accidentally extinguished, the gas escapes into the
room!
•
Be very precise when placing the burner crown cap upon the
crown. Always keep the crown nozzles clean and free.
crown cap
thermal coupling
(certain models only)
ceratin models only
burner crown
correct position of burner
components
Ignition and operation of burners
Gas burners may be ignited by means of electric ignition spark
plug, fitted adjacent to each burner (certain models only).
Single handed ignition
(certain models only)
To ignite the burner, press the selected burner button and turn
it to the maximum power position
. Electric spark from the
ignition device ignites the gas.
If the ignition device is out of order, either due to power failure
or humid ignition device, use a match or a lighter to ignite the
gas.
Ignition with both hands
(certain models only)
To ignite the burner, press the selected burner button and turn
it to the maximum power position
. Now press the ignition
device button. Electric spark from the ignition device ignites the
gas.
If the ignition device is out of order, either due to power failure
or humid ignition device, use a match or a lighter to ignite the
gas.
•
Keep the button pressed for approximately 10 seconds after
ignition to stabilize the flame.
•
If you failed to ignite the burner after 15 seconds, shut the
burner off and wait for at least one minute before the next
attempt.
