8
You are now a user of the newest generation kitchen extractor hood of DVG 8640 X / DVG
6640 AX type.
This hood has been designed and manufactured specially with a view to satisfying your
expectations and it will certainly constitute a fitting element of a modern kitchen. The modern
structural solutions and the newest technologies used in production of this hood guarantee its high
effectiveness and good appearance.
Please read these instructions carefully before installing the hood. They will make you avoid
mistakes during installation and operation of the hood.
We wish you a lot of satisfaction from choosing our kitchen extractor hood.
CONTENTS
I Characteristics
II Components
III Technical data
IV Operating conditions
V Installation
1. Installation of the hood
2. Connecting to the power network and operation check
3. Setting the operation mode of the kitchen extractor hood
3.1. Setting the air extractor mode of operation of the hood
3.2. Setting the odour absorber mode of operation of the hood
3.3 Fan speeds
VI Operation and maintenance
1. Operational safety
2. Operation
2.1. Control panel
2.2. Program function
3. Maintenance
3.1. Metal grease filters
3.2. Carbon filter
3.3. Lighting
3.4. Cleaning
I Characteristics
DVG 8640 X / DVG 6640 AX kitchen extractor hood was designed to remove kitchen fumes. It requires
installation of a conduit discharging used air to the outside. The conduit (usually a pipe Ø150 or 120 mm)
shall not be longer than 4-5 m. The hood can operate as an odour absorber after installation of an active
carbon filter. In such case a conduit discharging used air to the outside is not necessary, but it is
recommended to install an air exhaust guide.
The kitchen hood is an electrical appliance manufactured according to class II of shock protection.
It has its own lighting and an exhaust fan which can be set to one of three rotational speeds.
The hood was designed for permanent installation on a vertical wall over a gas or electric cooker.
II Components
The hood consists of the following elements (Fig. 1):
1.
Hood body with a glass [A], equipped with glass, lights and the fan unit,
2.
The decorative cover consisting of the top funnel [C] and the bottom funnel [B],
3.
Wall hanger of the hood [D] and the hanger of the top decorative cover [E],
4.
Set of mounting plugs.
