11
4.2 Setting the odour absorber mode of operation of the hood
In this option filtered air returns to the room through cut outs on both sides of the top funnel.
In this setting it is necessary to install the carbon filter; installation of the air exhaust guide is
recommended.
4.3 Fan speeds
The lowest and medium speeds should be used under normal conditions and with low concentration of
fumes. The top speed should be used in case of high concentration of kitchen fumes, e.g. during frying or
grilling.
VI Operation and maintenance
1. Operational safety
All safety instructions included in this manual shall be observed without exception!
Grease filters and active carbon filters should be cleaned and replaced according to manufacturer’s
instructions, or more frequently in periods of intensive use (more than 4 hours a day).
If a gas cooker is used it is forbidden to leave uncovered flame. When removing pots from gas burners set
the flame to its minimum level.
Always make sure that flame does not extend outside the pot. Such a situation causes undesired energy
losses and dangerous heat build-ups.
The hood should not be used for other purposes than those for which it was designed.
2. Operation
2.1 Control panel
Operation of the hood can be controlled by means of a combined switch.
Sensor ''Slider''- adjust the fan speed level, ranging from 1 to 9,
Sensor ''On / Off''(I / 0)
- turns on and off the fan
-
turns on the fan, on last memorized fan speed,
-
longer touch “on / off” sensor, when the fan is turned on, 5 min. timer is on (informing - a dot
on the display).
Sensor ''Light''(L)
-
turns on / off lighting
-
longer touch causes a gradual brightening / dimming of lighting, on 3 levels of 100, 75 and
50%
2.1 Program function
Timer function: DVG 8640 X kitchen extractor hood is equipped with the option of programming
automatic switch-off of the hood fan after 5-minute. “Timer” is actuated by pressing „I/0” indicator during
operation of the hood with the required fan speed. The display will flash and a dot will appear indicating
that the device is in the switch-off time programming mode. After setting the delay pulsating dot will
indicate that the time to switching off of the hood motor is being counted.
