6
Removing the metal front:
INSTALLATION OF THE DOOR PANEL
Remove the screw at the bottom of the door panel
using the Allen key supplied with the product.
Wiring the door panel:
AP- C1 NA1
AP+
CV-
BUSBUS
CV+
Remove the metal front as shown in the drawing.
Positioning the door panel:
Present the shield and the electronic module to the wall, placing
the top of the module at a height of 1.65m from the ground, and
pass the wiring through the cable entry.
Make 4 x 6mm diameter holes, two located at the top of the
module and the other two at the bottom, and fix the shield and
electronic module to the wall using the plugs and screws supplied.
Important:
The distance between the top of the electronic module
and the shield should be 7mm, so that the metal front can be
correctly positioned when closing the door panel.
To access the connection
terminals, remove the card
reader.
JAZZ GB2 VIDEO DOOR ENTRY SYSTEM KIT - HOUSE
Then connect the wiring to the
connector strip of the electronic
module, following the instructions
in the wiring diagrams.
