7
INSTALLATION OF THE DOOR PANEL
Codes assigned to the door panel call buttons:
Button 'P2': Codes 16-21.
.
(Apartment 2) 2-button door panels only.
Button 'P1': Codes 0-5.
(Apartment 1).
The sound module's P1 and P2 buttons are assigned with factory codes.
-
Apartment 1, button 'P1':
Enables codes 0-5 to be assigned to the monitor.
Monitors in this apartment must be set with codes in order of allocation from 0 to 5.
When button 'P1' on the door panel is pressed, all of the monitors in apartment 1 will receive the call and only
the monitor assigned with code 0 will show the door panel image. If the call is answered from any other
monitor in the apartment, the image on the monitor assigned with code 0 will disappear and audio and video
communication will be established with the door panel.
-
Apartment 2, button 'P2':
Enables codes 16-21 to be assigned (2-button door panel only).
Monitors in this apartment must be set with codes in order of allocation from 16 to 21.
When button 'P2' on the door panel is pressed, all of the monitors in apartment 2 will receive the call and only
the monitor assigned with code 16 will show the door panel image. If the call is answered from any other
monitor in the apartment, the image on the monitor assigned with code 0 will disappear and audio and video
communication will be established with the door panel.
Description of the configuration DIP switch:
ON
1
2
3
The configuration DIP switch is located on the right side of the electronic module,
accessible by opening the door panel (remove the protective silicone cover).
1 2
3
ON
Door panel address: (DIP 3 always OFF).
DIP switches: 1 and 2 OFF (address 1), 1 ON and 2 OFF (address 2), 1 OFF and 2
ON (address 3), 1 and 2 ON (address 4).
With DIP 1 and DIP 2 OFF (DIP 3 always ON), the following can be configured:
See pp. 9-10.
-
With button 'P1', ringtone operating mode during a call process.
-
With button 'P2', whether the door panel is installed with or without shield.
*
( )
*
( )
Factory setting.
*
( )
ON
1
2 3
AP- C1 NA1
AP+
CV-
BUSBUS
CV+
1.
To select the address of the door panel (DIP 3 must always be OFF):
2.
To configure the door panel (DIP 3 must always be ON):
1 2
3
ON
With DIP 1 ON and DIP 2 OFF (DIP 3 always ON), the following can be configured:
See pp. 9-10.
-
With button 'P1', lock release output 'CV-' and 'CV+', whether N.O. (factory setting) or N.C.
-
With button 'P2', activation time of lock release and auxiliary device outputs.
1 2
3
ON
With DIP 1 OFF and DIP 2 ON (DIP 3 always ON), the following can be configured:
See pp. 9-10.
-
With button 'P1', operating mode of card reader illumination.
-
With button 'P2', operating mode of door panel illumination LEDs with low light.
1 2
3
ON
JAZZ GB2 VIDEO DOOR ENTRY SYSTEM KIT - HOUSE
