Gold Medal Macho Pop 2553 Series, Инструкция по эксплуатации

Страница: 20 / 43

Macho Pop Model No. 2553 Series and 2554 Series
Page 20
gmpopcorn.com
Steps to Program a Parameter:
1. Use the “UP” and “DOWN” arrow buttons to select the parameter to be programmed.
The LED light next to the selected parameter will turn ON to indicate it is active, and
the 3 Character LED Display will show the current setting for that parameter.
2. Press and hold the “SEL” (select button) for 3 seconds to enter the programming mode.
The active LED starts to blink ON/OFF indicating it is in the programming mode.
Note: If no button is pushed within 10 seconds, the control will automatically exit the
program mode and the old values will remain unchanged.
3. Adjust the value displayed using the “UP” or “DOWN” arrow buttons.
4. Once the desired value is reached, press “SEL” to save the se tting and exit the
programming mode. The active LED will stop flashing.
5. Repeat the steps above to change additional settings, if needed.
Error Conditions for the Electronic Control
There are six error conditions which can be detected by the control. If an error condition is
detected, the control will disable the heat output, and the Dump Light will flash the number of
times to indicate the error code (if Audio Volume is on, the control will also beep to indicate the
error code). The LED Display will indicat e the error code by alternating the message “err” and the
error code (1-6). This sequence will repeat until the error condition is corrected, and the Heat
Switch is cycled OFF then back ON.
For example: If an Open Probe (code 2) is detected, the Dump Light will flash 2 times (and
if enabled, the sound will beep 2 times) then pause with no light (or sound)
for period of 3 seconds. The LED Display will show the code 2 error by
alternating the message “err” and 2.
The following list describes each error code condition:

Reversed Probe (code 1) – Error code 1 indicates the thermocouple probe has been
connected in reverse. (The yellow leads must be to the positive terminals.)

Open Probe (code 2) – Error code 2 indicates the thermocouple probe is disconnected.

Loop Break (code 3) – The Loop Break is factory set to zero, and should NOT be
adjusted, so this code is not applicable to this unit.
 Kettle heating when no heating commanded (code 4) – If the control and limit relays
stick on, the kettle will heat even with the heat switch off. For this condition the control will
show error code 4.

Wrong voltage to heat elements (code 5) – The voltage slope parameter is factory set
to zero, and should NOT be adjusted, so this code is not applicable to this unit.

Maximum kettle temperature exceeded (640°F) (code 6) – Error code 6 indicates the
kettle heat has exceeded the maximum temperature of 640°F. This error condition will exist
until the sensed temperature is less than 550°F, which is below the high limit set point.