Gold Medal Macho Pop 2553 Series, Инструкция по эксплуатации, Страница: 18 / 43

Macho Pop Model No. 2553 Series and 2554 Series
Page 18
gmpopcorn.com
Electronic Temperature Control
Operation
The temperature control is factory set to stop the power to the kettle when the thermocouple
reaches set point. This is also the ideal point to dump the popped corn out of the kettle. On the
first start-up, this is the ideal time to load the corn and oil. Therefore, if the Kettle Heat Switch is
turned ON and the buzzer is sounding, one of the following actions should be taken:

Load the corn and oil or

Dump the popped corn from the kettle or

Turn OFF the Kettle Heat Switch if you are finished popping corn.
Control Description
This unit has an electronic kettle heat control with 2 thermocouples (TC), one for set point control
and one for fixed high limit. There are no mechanical thermostats in this kettle.
There are (7) factory parameters on the control (see descriptions below). If needed, adjustments
may be made to Kettle Dump, Audio Volume, and Auto Shut Off (see Programing the Electronic
Control on next page). The remaining settings are factory set for the unit, DO NOT adjust.
1. Set Point Temperature – This is factory set, DO NOT adjust.
2. Overshoot – This circuit is tuned for the kettle at the factory, DO NOT adjust.
3. Kettle Dump – The Kettle Dump Offset is factory set at 37°F (valid range is 0 to 50).
This notes the dump point temperature is 37°F less than the set point temperature.
For the signal to dump to sound sooner, increase the degree value; to sound later,
decrease the degree value.
L2 Neutral Lead
L1 Hot Lead
It does not matter which TC goes to A
or B; it
DOES matter that the yellow
leads go to the positive terminals.
Controls used for Programming the Unit
3 Character
LED Display
Parameters with
LED indicators (3) Push
Buttons