Macho Pop
Model No. 2553 Series and 2554 Series
Page 10
gmpopcorn.com
6.
When finished popping, turn KETTLE HEAT and KETTLE MOTOR switches OFF.
NEVER LEAVE THE HEAT ON WHEN YOU ARE NOT POPPING CORN!
If Auto Shut-OFF is enabled, unit will automatically shut kettle heat OFF after 15
minutes of idle time (no popcorn popped). To restart kettle heating, cycle the Heat
Switch OFF-ON.
Popping Sweet Popcorn (if equipped)
Gold Medal recommends white coconut oil for popping Glaze Pop (colored oil can change the
popcorn color). Glaze Pop cooks directly in the kettle.
DO NOT
use popcorn seasoning salt when
popping Glaze Pop.
Kettle Size
Popcorn Charge
Oil Charge
Glaze Pop/Sugar
16 oz.
16 oz. (473 ml)
5 oz. (148 ml)
8 oz.
Note:
When popping with coconut oil, be sure oil is liquid. As a check, dispense oil
into a measuring cup first then use that oil for the first popping cycle.
1.
Turn all switches ON; set Salt-Sweet Switch to Sweet mode.
2.
When kettle is ready (about 4 minutes), the Load/Dump Light and Audible Signal (if
enabled) will turn ON.
3.
Lift kettle lid and pour in pre-measured amount of corn.
4.
Add oil. If equipped with oil dispense unit, p
ress the “Red” Oil Dispense PB Switch to
add oil (the Load/Dump Light and Signal will turn OFF in approx. 20 seconds).
5.
Add pre-measured amount of Glaze Pop or Sugar (when using sugar, we recommend
using Compound “S” to help keep kettle clean); close lid.
6.
When corn has finished popping, the Load/Dump Light and Audible Signal will turn
ON, then gently dump the popcorn.
Note:
The signal “To Dump” was factory set based on Gold Medal popcorn
and oil. If,
after 3 consecutive batches, the signal occurs before or after popping has
stopped, the signal timing can be adjusted. Have a qualified service person adjust
the signal to dump (reference Electronic Temperature Control section).
7.
On final kettle of corn, turn Kettle Heat Switch OFF just as lids are forced open by the
popping corn. This procedure saves electricity, since kettle has plenty of heat, and helps
eliminate smoke/odor from any oil residue that remains after popping has stopped.
Note:
When Kettle Heat Switch is OFF, machine will not beep on the last batch.
8.
When finished popping, turn KETTLE HEAT and KETTLE MOTOR switches OFF.
NEVER LEAVE THE HEAT ON WHEN YOU ARE NOT POPPING CORN!
If Auto Shut-OFF is enabled, unit will automatically shut kettle heat OFF after 15
minutes of idle time (no popcorn popped). To restart kettle heating, cycle the Heat
Switch OFF-ON.
9.
Clean kettle when finished popping Glaze Pop or sugar corn, and prior to switching to
popping salted popcorn.
Содержание Macho Pop 2553 Series
Страница 40: ...Macho Pop Model No 2553 Series and 2554 Series Page 40 gmpopcorn com Front Counter Model Series 2554 ...
Страница 41: ...Macho Pop Model No 2553 Series and 2554 Series Page 41 gmpopcorn com Back Counter Model Series 2553BC ...
Страница 42: ...Macho Pop Model No 2553 Series and 2554 Series Page 42 gmpopcorn com Back Counter Model Series 2554BC ...
