GoHigh MG3000-R, Руководство пользователя

Страница: 46 / 135

- G.726_32
- G.726_40
- iLBC_13
- iLBC_15
Other Codec Type Select other codec types which may be supported at the
same time. Select other coder types which may be
supported at the same time.
G.726_16 PT Value Set the payload type if using G.726_16 coder. The range is
96 ~ 127
Note: for the coder type, such as G.726_16, G.726_24,
G.726_40, ILBC_13, iLBC_15, DTMF2833 etc., you should
avoid setting them in the same value.
102
G.726_24 PT Value Set the payload type if using G.726_24 coder. The range is
96 ~ 127 103
G.726_40 PT Value Set the payload type if using G.726_40 coder. The range is
96 ~ 127 104
iLBC_13 PT Value Set the payload type if using iLBC_13 coder. The range is
96 ~ 127 105
iLBC_15 PT Value Set the payload type if using iLBC_15 coder. The range is
96 ~ 127 106
Fax Configuration
Fax Trans Mode Fax Configuration:
- T.38
Pass through
( if use this mode, you should choose G.711 voice codec) T.38
T.38 Fax ECM Set T.38 ECM error correction function.
- Yes
- No Yes
T.38 Error Recover
Method Set T.38 recovery mode:
Redundancy
- FEC Redundancy
Redundance count for
fax page data Set the redundance count for fax page data.
When T.38 fax fails, you can withdraw redundant data to
recover. The bigger the value is, the larger the data packet
of fax will be (because it includes redundant information).
The options are:
- 0
- 1
- 2
- 3
0
Redundancy count for
T.30 Messages Set T.30 redundancy count of T.30 message.
When T.30 message transmission fails, you can get the
redundancy message to recover. The larger the value is, the
bigger message of T.30 will be.
The options are:
- 0
- 1
- 2
- 3
- 4
- 5
- 6
- 7
3
TCF Trans Mode Set TCF (Training Check Field) mode. Before you send a
fax, there is a TCF, which can be used to confirm the
situation of the line.
The options are:
Remote
- Local
Remote
T.38 Fax Relay
Volume
Set T.38 fax gain. the range is -15~6dB, in 1 dB increment -6
T.38 Fax Relay Max Set the max fax rate: 14400bps