EZ300 Series
13
2-6
Loading The Label Roll
(Cutter Model)
Pass the labels through the guides.
Close the printing mechanism.
To finish, press the FEED button to set the label position.
! NOTICE
Do not use to cut adhesive labels! Glue residue will be left on the cutter blade and impair its functioning.
The cutter has a blade life of 400,000 cuts when using paper liner which is 0.2mm thick and 3 inches wide.
You can cut paper with a max. width of 116 mm.
Labels should be at least 30 mm high to ensure correct functioning of the cutter.
With the cutter installed, setting the stop position in GoLabel to 30, or the E value to 30 is recommended.
If you use cutter, please do not use inside wound media while printing, otherwise the breakdown may occur.
Through the cutter module
Through the label guides
Press the FEED key
LABEL GUIDES
