GMI D6031D, Инструкция по эксплуатации

Страница: 9 / 9

9
D6031 - SIL 3 Switch/Proximity Detector Repeater Open Collector Output G.M. International ISM0214-2
Line fault detection SW1
Disabled
(switch/proximity sensor)
OFF
Enabled, for SIL application
(proximity sensor or switch with end of line resistors,
detects field open circuit and short circuit,
de-energizes relay in fault condition)
ON
SW5
OFF
ON
IN/OUT Operation SW2
NO-NC or NC-NO ON
NO-NO or NC-NC
(for SIL application)
OFF
D6031S Configuration Summary Table
WARNING: Dip-switch 7-8 must be set to “OFF” position.
Channel 2
Line fault detection SW1 SW5 SW3
Disabled
(switch/proximity sensor)
OFF OFF OFF
Enabled, for SIL application
(proximity sensor or switch with end of line resistors,
detects field open circuit and short circuit,
de-energizes transistor in fault condition)
ON ON ON
1
IN/OUT Operation SW2
NO-NC or NC-NO ON
NO-NO or NC-NC
(for SIL application)
OFF
Channel 1 2
SW4
ON
OFF
Output 2 Operation SW6 SW7 SW8 Mode SW4
Duplicator
De-energized in
fault condition
(for SIL application)
if line fault
detection enabled
(SW1 ON)
ON
OFF ON
Parallel
(for SIL
applica-
tion)
Set equal
to SW2
Not specified
Fault condition
OFF Reverse
Set opposite
to SW2
OFF
(for SIL application)
ON OFF
NO ON
NC
(for SIL
applica-
tion)
OFF
Fault Output
D6031D (used as double channel) Configuration Summary Table
WARNING: dip-switch 6-7-8 must be set to “OFF” position.
D6031D (used as duplicator or fault output) Configuration Summary Table
WARNING: Terminals 9-10 must be shorted to set module as Duplicator or Fault Out. Dip-switch 3 must be set to “OFF” position.
SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
OFF OFF OFF OFF OFF OFF OFF OFF
DIP Switch factory settings (valid for D6031S and D6031D)
Configuration
Line fault detection SW1 SW5
Disabled
(switch/proximity sensor)
OFF OFF
Enabled, for SIL application
(proximity sensor or switch with end of line resistors,
detects field open circuit and short circuit,
de-energizes relay in fault condition)
Output 1,
(for SIL application)
De-energized in Fault condition
ON
Output 1,
Not specified Fault condition
OFF
ON
IN/OUT Operation Output 1 SW2
NO-NC or NC-NO ON
NO-NO or NC-NC
(for SIL application)
OFF