Page 28
1OPVM26EN – April 2018
VM26-J
Transport and Lifting Instructions
Driving or Winching onto or off of a Transport Vehicle
Always attach the machine to a winch when loading or unloading from a truck or trailer by driving.
Read and understand all safety, control, and operating information found on the machine and in this
manual before operating the machine.
Before loading or unloading the machine, check that:
• The covers, controls and component trays are secure.
• The platform is fully lowered.
• All loose items have been removed.
Before driving or winching the machine:
• Attach the machine to a winch.
• Remove all machine tie downs. Remove wheel chocks.
Driving
• Turn the Key Switch to PLATFORM. Check that the Emergency Stop Switch is reset
by pulling it out.
• Enter the platform and reset the Platform Emergency Stop Switch.
• Test platform control functions.
• Select slow drive speed mode. Carefully drive the machine off the transport vehicle
with the winch attached.
Note:
The brakes are automatically released for driving and will automatically
apply when the machine stops.
Winching
• Carefully operate the winch to lower the machine down the ramp.
• Chock the wheels and engage the brakes.
Securing to Truck or Trailer for Transport
• Turn the Key Switch to OFF and remove the key before transport.
• Inspect the entire machine for loose or unsecured items.
• Chock the wheels
• Use the tie-down points on the chassis for anchoring down to the transport surface.
• Use chains or straps of ample load capacity. Use a minimum of four (4) chains or
straps. Adjust the rigging to prevent damage to the chains and the machine.
Ensure that angle of each hold-down chain or strap does not exceed 30° relative to the trailer deck.
•
13360
30°
30° Maximum
Tie Down Angle
Steeper angles
may damage
machine
