1OPVM26EN – April 2018
Page 19
VM26-J
Operating Instructions & Function Tests
Driving On A Slope
DO NOT drive the machine on a slope with the platform elevated.
The platform must be in the fully stowed position before driving on a slope.
Determine the slope and side slope ratings for the machine and determine the slope grade.
Maximum forward/rearward slope rating, stowed position 23%.
Maximum side slope rating, stowed position 3°.
Note:
Slope rating is subject to ground conditions and adequate traction.
Press the Drive Speed button so that the light is on to engage slow speed drive mode.
To determine the slope grade
Measure the slope with a digital inclinometer OR use the following procedure.
You will need:
• Carpenter's level
• Straight piece of wood, at least 3.3 ft / 1 m long
• Tape measure
Lay the piece of wood on the slope.
At the downhill end, lay the level on the top edge of the piece of wood and lift the end until the
piece of wood is level.
While holding the piece of wood level, measure the distance from the bottom of the piece of
wood to the ground.
Divide the tape measure distance (rise) by the length of the piece of wood (run) and multiply
by 100.
Example:
Run = 12 ft / 3.6 m
Rise = 12 in / 0.3 m
12 in ÷ 12 ft = 0.083 × 100 = 8.3%
0.3 m ÷ 3.6 m = 0.083 × 100 = 8.3%
If the slope exceeds the maximum slope or side slope rating, the machine must be winched or
transported up or down the slope. See Transport and Lifting section.
Shutdown Procedure
• When finished with the machine, place the platform in the stowed position.
• Park the machine on a level surface.
• Turn the Key Switch to the OFF position and remove the key to prevent
unauthorized use.
• Carefully exit the platform using a constant three (3) point dismount/grip.
• Push in the red Main Power/Lower Emergency Stop Switch button to the OFF
position when leaving the machine at the end of the work day.
• Charge the batteries.
13323
