W 1
I n s t r u c t I o n m A n uA l
PA G E 5
position and fit the two m4 bolts. tighten firmly so that the clamp does not
move when the buttons are pressed. Do not over tighten.
NOTE:
If the m4 bolts provided are too short for your steering wheel, they can
be replaced with m4 bolts of a suitable length obtained from your local hardware
store. Ensure the bolt lengths are not too long, otherwise they may foul on the
back cover.
For mounting onto larger steering wheels, a spacer kit is provided which
includes two spacers of varying thickness and longer 30mm m4 bolts. If
required, fit one or more spacers between the front and rear clamp as shown
then tighten firmly using the longer bolts.
Panel Mount
the W1 can also be mounted onto a flat surface using the supplied adhesive foam.
mount the W1 in a location that is easy to reach without distraction while driving.
NOTE
- installing onto a metallic surface will reduce the signal range.
to avoid personal injury, Do not install the remote control
on any surface associated with your vehicle’s airbag.
the adhesive foam is in two sections and is designed to
align with the rear mounting holes and the battery cover.
to aid in accurately fitting the adhesive foam, proceed
as follows;
1. starting at the top, fold the backing sheet away from the
top half of the adhesive foam. leave the backing sheet
attached to the bottom half of the adhesive.
2. With the remote unit’s GmE label at the top, position
the sticky side of the adhesive foam onto the back of
the remote unit, aligning the screw holes and battery
compartment with the matching section on the adhesive
foam. Press the foam firmly into position.
Insert spacer
as required
30mm m4 Bolt
thick spacer thin spacer
