GLP Highlander Wash, Быстрый старт и руководство по безопасности

Страница: 6 / 36

www.glp.de
6
Highlander Wash Quick Start and Safety Manual
precautions it contains before installing or using the fixture. GLP and affiliated
companies will take no responsibility for damage or injury resulting from disregard for
the information in the fixture’s user documentation.
●
Check the GLP website at www.glp.de and make sure that you have the latest
version of this manual. Check the fixture software version indicated on page 2 of this
manual and then use the fixture’s control panel to check the version installed in the
fixture. If the versions are not the same, this manual may still cover the fixture,
because software updates do not always affect the use of the fixture. However, it is
possible that this manual does not match the fixture perfectly. Software release notes
can help clarify this question. You can consult software release notes and download
the correct version of this manual on the GLP website if necessary.
●
Make all user documentation available to all installers and operators. Save user
documentation for future reference.
●
If you have any questions about the safe operation of the fixture, please contact an
authorized GLP distributor (see list of distributors at www.glp.de).
●
Use the fixture only as directed in this manual. Observe all markings in this manual
and on the fixture.
●
Refer all repairs and any service operation not described in this manual to a
technician authorized by GLP.
●
Read and follow the user documentation for all additional equipment.
Electrical safety
●
Do not allow the fixture to come into contact with water or moisture.
●
Use only a source of AC mains power that complies with local building and electrical
codes and has both overload and ground-fault (earth-fault) protection.
●
Ensure that the fixture is electrically connected to ground (earth).
●
Disconnect the fixture from AC mains power before carrying out any installation or
maintenance work and when the fixture is not in use.
●
Disconnect the fixture from power immediately if any seal, cover, cable, connector
or other component is damaged, defective, deformed or showing signs of
overheating. Do not reapply power until the fixture has been repaired and made
safe by a technician authorized by GLP.
●
Check that all power distribution equipment, cables and connectors are in perfect
condition, rated for the electrical requirements of all connected devices, suitable for
their application and suitable for the installation environment.
●
Use only a Neutrik powerCON TRUE1 cable connector for AC mains power input at
the fixture’s MAINS IN connector. If the connector and its keys are not in perfect
condition, install a new TRUE1 connector on the cable following the instructions
available on the Neutrik website before connecting the cable to power. Send the
old connector for waste recycling.
PRELIMINARY