206M 201805
27
will be finished after two seconds. The machine enters normal dynamic balancing
mode(clamp counterweights on the both rim edge) automatically, as in Fig 7-1, ready for input
data of rim
Fig 7-1
7.2 Data of wheel input method for normal dynamic balance mode and wheel balancing
operation
7.2.1After power is on, machine enters normal balancing mode, as below figure
7.2.2Input rim data
：
Fig 7-2
Move scale to make handle head touch rim edge inner position as Fig 7-2, get value a,
put back scale. Push [a-] or [a+] to input a value
7.2.3Input rim width
Get rim width data showing on rim , or measure rim width by caliper, push [b-] or [b+] to
input b value
7.2.4Input rim diameter
Get rim diameter data showing on rim , or measure rim diameter by caliper, push [d-] or
[d+] to input d value
7.2.5 Balancing operation against normal dynamic balancing mode
Input rim data, manually rotate wheel, when display shows “RUN ---”, move hand away
to let wheel rotate. When display shows “STOP”
，
wheel stops and display shows data. Slowly
rotate wheel, when inside position indication LEDs all light,
（
Fig 5-1
（
10
）
）
, at the 12 o’clock
position of rim inside , clamp weights equal to value shown on the left side display
（
Fig 7-3
）。
Then slowly rotate wheel, when outside position indication LEDs all light,
（
Fig 5-1
（
11
）
）
, at the
12 o’clock position of rim outside , clamp weights t equal to value shown on the right side
display
（
Fig 7-4
）
. Rotate wheel by hand again, move hand away when display is off. When
both side display are on, wheel stops and balancing is completed.
