206M 201805
26
[MODE] Function key of selecting balancing mode
[FINE]+ [SET] Self-calibration
[FINE]+ [a
↑
] + [a
↓
] conversion between gram and ounce
[SET] + [MODE] Self-testing
[FINE] + [MODE] Machine setting
NOTE:
1. After selection of gram or ounce, setting can remain after machine power off
2
、
Choose unit of mm for rim width and diameter, setting cannot remain after machine
power off
6. Installation and Demounting of the Wheel
6.1 Checking the wheel
The wheel must be clean, none sand or dust on it, and remove all the primal
counterweights of the wheel. Check the tyre pressure whether up to the rated value. Check
positioning plane of rim and mounting holes whether deformed.
6.2 Installing the wheel
6.2.1 Select the optimal cone for the center hole when there is center hole on the rim.
6.2.2 Two ways of installing the wheel: A. positive positioning; B. negative positioning.
6.2.2.1 Positive positioning (refer to Fig 6-1):
Positive positioning is commonly used. It operates easily, and it is applicable for
various rims of common steel structure and thin duralumin structure.
6.2.2.2 Negative positioning (refer to Fig 6-2):
Negative positioning is used to ensure the inner hole of steel rim and main axis is
positioning accurately when the outside of wheel deforming. Apply for all the steel
rims, thick steel rims especially.
6.2.3 Install wheel and cone on main axis. Ensure the cone can clamp the wheel before
screwing handle. Wheel can rotate after screwing down
6.3 Demounting the Wheel
6.3.1 Demount the handle and cone.
6.3.2 Put the wheel up, and then take it down from main axis.
Fig 6-1 Fig 6-2
Note: do not slip wheel on main axis to prevent main axis from scuffing while installation
and demounting the Wheel
7. The input methods of data of rim and balancing operation
7.1 The power-on state of the machine
After the power-on of the machine, it starts initialization automatically. The initialization