7
6. Front panel
POWER KEY: To switch the receiver power on/stand by
v ,^ KEY : To change channels, or to move cursor up or down in the menu
POWER Led: Lights up while the receiver is power on
Remote Sensor: Detects infrared signal from remote control unit
Display(4-Digit/7-Segment): Indicates operating status of receiver
Signal Led: When receiving signal is strong, the signal led is lighted.
VOL<,> KEY (optional): To adjust volume level, or to move cursor left or right in the menu
MENU KEY (optional): To enter into the main menu
OK KEY (optional): To see TV/Radio channel list, or to confirm in the menu
Exit (optional): Cancel the user selection and return to the viewing mode from a menu.
7. Rear Panel
Please refer to the diagram above for all possible connections of your receiver
Do not connect the unit to the mains socket until all other connections have been made and
checked.
GLOBO 7010CR, OPTICUM 7000CR, OPTICUM 7100CR:
Opticum 4000TS, Opticum 4100TS, Opticum 4000TSCR, Opticum 4100TSCR:
AERIAL OUT (optional): This enables the connection of another receiver.
AERIAL IN (optional): This port is to connect the coaxial cable from terrestrial antenna.
LOOP OUT: This enables the connection of another receiver.
13/18V 500mA MAX LNB IN: This port is to connect the coaxial cable from LNB of your Dish.
VIDEO: This RCA connector is used to connect any external video.
0-12V: This is used to Connect 12V to an external 0V/12V switch.
AUDIO R/L: These RCA connectors are used to connect any external audio amp or system.
RS 232C SERIAL PORT: This is used to connect your receiver to a computer through
