Page 11
6. Use the carriage handle to tilt carriage and carriage arm to the right to the cleaning
position (Fig. 11-1 and Fig. 11-2).
7. With a clean cloth soaked in mild detergent, wipe down the carriage. Use a clean,
wet cloth to rinse the carriage. Finish by spraying sanitizer on the carriage and
then let air dry.
BE ALERT. The next step will expose knife.
8. Remove knife cover. Push down on knife cover release lever. Hold the knife cover
release lever and pull knife cover forward to remove knife cover from top pin
(Fig. 11-4).
9. Hold the knife cover release lever. Carefully tilt knife cover and pull knife cover up
and to the right to remove the knife cover from bottom pins.
10. Remove knife sharpener. Pull knife sharpener up and away to remove from slicer
(Fig. 11-5).
Note: If using the front mounted sharpener, refer to Front Mounted
Sharpener section.
Note: If slicer is equipped with removable knife option, refer to Removable
Knife Option section.
BE ALERT.
Slicer knife edge is exposed. Always be aware of the
placement of your hands/fingers in relation to knife.
Cleaning & Sanitizing
DISASSEMBLY & CLEANING
1. Push STOP button to turn off knife motor.
2. Turn slice thickness dial clockwise past zero (0) until it stops so table covers
knife edge.
3. Unplug power cord.
Note: When slicer is unplugged the white POWER indicator light will go
out.
4. Pull carriage toward you (home position).
Note: The carriage will only tilt back in the “home” position.
5. Loosen the carriage release knob that fastens the carriage to the slicer
(Fig. 11-3).
Note: The carriage release knob is not designed to come completely off.
Figure 11-3
Figure 11-2 Cleaning Position
Figure 11-1
Figure 11-5
Figure 11-4