8
Continued On Next Page
☛
☛
☛
☛
☛
❑
Drill a 45º angled hole up through the center of one support plate,
through the fuselage and through the other support plate.
❑
Drill a 45º angled hole up through the center of the other side of the
support plate. Position this hole slightly in front of the other hole, so that
the holes don't interfere with each other.
❑
Glue one angled bracket onto one end of one carbon strut.
✦
✦
✦
✦
✦
IMPORTANT
✦
✦
✦
✦
✦
Note the position of the bracket. The angled sides
should be away from the end of the carbon strut.
❑
Slide the carbon strut down through one of the holes in the support
plate and push the mounting bracket against the support plate.
❑
Slide a second mounting bracket over the carbon strut (from the
bottom) and push the bracket up against the support plate.
❑
Align the carbon strut so that it's straight (when viewed from the
side), then glue the two mounting brackets and the carbon strut into place.
❑
Cut the two carbon struts to a length of 6-1/2" (165mm).
