Global Hobby Phase 3 Pitts, Инструкция по эксплуатации

Страница: 10 / 16

10 Continued On Next Page
☛ ☛
☛ ☛ ☛
❑
Install the second wheel and wheel pant assembly. Before gluing the axle mounting bracket into place, make sure that the wheel
pant points straight ahead and that the wheel pant is even with the other wheel pant when viewed from the side.
❑
Slide the axle mounting bracket onto the end of the carbon strut,
then line up the wheel pant. It should point straight ahead and should
also be level when viewed from the side.
❑
Glue the axle mounting bracket to the carbon strut.
✦ ✦ ✦ ✦ ✦
IMPORTANT
✦ ✦ ✦ ✦ ✦
Before gluing the axle mounting bracket to the carbon struts, measure and make sure that both carbon struts
are the same length. If one is longer than the other, cut the longer one shorter so that they're both the same length.
STEP # 7: INSTALLING THE ELEVATOR AND RUDDER SERVOS
❑
Install the elevator and rudder servos into the fuselage. Use a couple
of drops of foam-friendly C/A to secure them into place. Notice that the
elevator servo is mounted on the left side of the fuselage and the rudder
servo is mounted on the right side of the fuselage.
✦ ✦
✦ ✦ ✦
IMPORTANT
✦ ✦
✦ ✦ ✦
The servo output shafts should be toward the front
of the airplane.
STEP # 8: INSTALLING THE ELEVATOR PUSHROD
❑
Make a Z-Bend in one end of one pushrod wire.
❑
So that you can adjust the length of the pushrod after it's installed,
make a V-Shaped bend 2" (51mm) behind the Z-Bend.
❑
Install one control horn onto the bottom of the left side of the elevator,
5/8" (16mm) out from the side of the fuselage, using the wood screws
provided.
❑
Attach the Z-Bend into the outermost hole in the servo arm.