Global Hobby Phase 3 Pitts, Инструкция по эксплуатации

Страница: 12 / 16

12 Continued On Next Page
☛ ☛
☛ ☛ ☛
❑
Slide one pushrod support (extra control horn) over the end of the
pushrod wire.
❑
Check that the servo arm is still centered, then center the rudder.
❑
Cut the pushrod wire to length, snap the clevis into the outermost
hole in the control horn, then glue the clevis to the pushrod wire.
❑
Center the pushrod support, then glue it to the fuselage side.
STEP # 10: INSTALLING THE AILERON SERVO AND PUSHRODS
❑
Center the aileron servo, then attach the servo arm onto the servo,
making sure that it's centered.
❑
Install the aileron servo to the left side of the fuselage, using a couple
of drops of foam-friendly C/A.
✦ ✦
✦ ✦
✦
IMPORTANT
✦ ✦
✦ ✦
✦
The servo output shaft should be toward the front
of the airplane and the servo arm should be centered in the cutout in
the fuselage.
❑
Install one control horn onto the top of both bottom wing ailerons,
5/8" (16mm) out from the sides of the fuselage.
❑
Make a Z-Bend in one end of two pushrod wires.
❑
Make a V-Shaped bend 1" (25mm) behind the Z-Bends.