SIM CARD CONNECTOR
MAINTENANCE
2.1 SIM CARD REPLACEMENT
This procedure is required when a software upgrade is supplied on a SIM CARD. The original SIM CARD
also holds all the system configuration (settings) so this data must first be uploaded to a PC in order that it
can be downloaded into the new SIM CARD once it has been fitted.
In some cases the replacement SIM CARD will have been pre-programmed with the site configuration. In
this case it is not necessary to upload the configuration from the original SIM CARD.
The procedure assumes that the power has been removed from the panel.
WARNING
ENSURE THAT THE POWER IS TURNED OFF
The SIM CARD is mounted on the back of
the main board.
Release the
by pulling in the
direction of the arrows (
).
With the retaining clips held in the released
position, push the SIM CARD forward and
down until it is almost horizontal with the
main panel board.
Lift the SIM CARD off the connector.
To install the replacement SIM CARD,
locate it on the connector almost
horizontally with the main panel board,
push it up and back gently until the
retaining clips snap into position.
Download the panel configuration from
the PC if SIM is not pre-programmed.
retaining clips
Uploading and downloading requires an RS232
lead and PC software.
See installation Manual Section 8-4-2 for
Upload/Download instructions.
ELECTRO-STATIC SENSITIVE DEVICES (ESD)
TAKE SUITABLE ESD PRECAUTIONS WHEN
REMOVING OR INSTALLING PRINTED
CIRCUIT BOARDS.
G L O B A L
F I R E
E Q U I P M E N T
JUNiOr
JUNIOR MAIN BOARD
SECTION 2 - MAINTENANCE
15
JUNIOR V3 - OPERATION & MAINTENANCE MANUAL - REVISION 2.3 - 17-SEP-2005
JUNiOr SIM CARD
