MAINTENANCE
2.5 GETTING INTO PROGRAMMING MODE
G L O B A L
F I R E
E Q U I P M E N T
JUNiOr
KEYPAD
18
JUNIOR V3 - OPERATION & MAINTENANCE MANUAL - REVISION 2.3 - 17-SEP-2005
ENTER
ESC
When the Panel is powered up it will be necessary to enter the panel programming mode. Familiarize
yourself with this section before proceeding to the next section in the manual and powering up the
panel.
Programming mode is accessed via the front panel keypad as pictured below.
To program device and zone text messages, it is essential to use the Loader PC based software.
Logging In
To enter programming mode you need to log in.
The Panel must be powered up and must have initialized itself i.e. NOT be showing the
‘INITIALIZING’ message.
Press ENTER on the Keypad. You must now input your Installer access code. See page 6 Access
Levels. You have unlimited attempts but if code entry is not started within 10 seconds then the panel
will revert back to it’s default screen. While entering the code you are allowed up to 5 seconds
between key presses.
The programming functions are arranged using a menu system.
To select a function or sub-menu use either
and ENTER.
ESC takes you up a menu level.
The top level menus are:
1 Review Historic Log
3 Zones - Disable & Assign
4 Sounders - Disable & Assign
5 Input/Output - Disable & Assign
6 Device Set-up
7 Monitor Device Counts & Test
8 General
Most functions operate in a consistent manner using the standard keys. The item that is being
changed is usually highlighted with a flashing cursor.
Function Selection
pq
