Gliderol Storm Safe, Инструкция по установке и эксплуатации

Страница: 13 / 20

13
2.6 Installing Panels cont...
Make sure front face of panels do not touch wall and have a minimum clearance of 3mm when closed.
IMPORTANT- Do not force the track too tightly against the rollers as this will cause the door to bind
when in operation.
Check that all door panels are level and make necessary adjustment with temporary packers. Once
satisfied secure all wall mounted Jamb brackets to eliminate any further track movement.
2.6 Installing Horizontal Tracks
Loosen the slide on each top bracket enabling easy roller adjustment. Use a suitable support to hold the
back of the horizontal track in position as illustrated below.
Attach the flag bracket to the curved section of the horizontal track using the 1/4’ x 5/8’ screws and nuts
ensure that the screws are on the inside of the track. Attach the end of the horizontal angle to the top
of the wall mounted flag bracket the 3/8’ x 3/4’ carriage bolt and nut. Make sure horizontal and vertical
tracks are aligned when joined.
Lower the final door panel into the vertical tracks. Fasten the hinges to the bottom of this panel. That is in
a four-panel door secure the hinges from the top of panel three to the bottom of panel four. This is done
to prevent the top panel from falling out of the vertical track. Now Horizontal track can be installed.
Secure the rear of the horizontal track with the steel angle. Due to the variance in installation
requirements within a garage these angles are not provided. The angle may be attached to return walls
or the ceiling. Make sure that the track is level and square with the opening. Due to the fact that the
horizontal tracks are weight bearing when the door is fully opened ensure that adequate fasteners are
used into solid fixings. Repeat this step for the second horizontal track.
The sliding section on the top door panel bracket should be loose. Push the top of the door tightly
against the opening and pull the roller towards yourself. Once satisfied that the roller is correctly
positioned in the track then tighten the slide bracket. If an operator is to be installed. Tighten bracket to
leave clearance between panel and lintel.