Glentek SMB9675-1A-1-7700, Руководство по установке и эксплуатации

Страница: 10 / 33

Chapter Three www.glentek.com
10 MANUAL # 9675-1035-000-A
%
N1 O6000 (RIGID TAP CYCLE)
N2 G80
N3 S750
N4 G91
N5 X0.1 Y0.1 G1 F10.
N6 M5
N7 G4 P2000
N8 G84.1 Z-1. R+0 F500. Q0.0714
N9 M45
N10 X-0.1 Y-0.1 G1 F10.
N11 M45
N12 M45
N13 M45
N14 M45
N15 G80
N16 G4 P2000
N17 M99 P5
N18 (!)
N19 (NOTE: O5827 CNC88 TEST WAS MOVED TO TA, 5!!!)
%
3801
Once the program is loaded, jog the z axis down so the screw can be indicated.
Type “SETZ” and press ENTER. Start the test program and observe that the program is running
correctly. Depress the SINGLE STEP key. Be sure the test screw returns to its original position.
Set the indicator as shown below, the tip must be touching the lower thread halfway into the thread,
the second thread from the bottom.
Run the test and observe the indicator. The reading should not deviate from zero
more than .002” on
either side of zero. If necessary, consult the FADAL maintenance manual for your machine.
Photo 4: Test screw
Photo 3: Test screw in setup with dial
indicator
Photo 5: Test screw in toolholder