9
GKD Technik Ltd
M3000007
Logging
This icon shows the status of the on-board data logging system. There are four
states for the icon.
1) Not shown
- logging is disabled.
2) Logging icon
- no events
recorded but Logging On.
3) Exclama�on mark
- Logging is on and an event has
been recorded.
4) Logging symbol with red cross
- Log is inopera�ve or card full.
Screen Layout con�nued...
8
9
10
11
12
13
14
15
16
18
Status Bar
This area shows machine informa�on, error messages and current date and �me.
Rated Capacity
Shows the maximum permitted load for the current height an radius.
Note:
when an
*
appears against this number, it will indicate that either the
machine is in hydraulic limit or the ra�ng displayed is the maximum based on the
hydraulic limita�ons of the machine.
Speed
Shows the current speed of the machine in MPH.
Duty Indicator
This symbol will indicate whether the RCI is switched to Rail du�es, Road du�es
or LUL (London Underground) du�es.
Slew
Shows the current slew angle in degrees. 0° is typically over the oscilla�ng axle.
Menu bu�on
Allows access to user and service func�ons.
Note:
if the machine controllers key switch is off then the system will not allow
access to service menus or limit func�ons.
RCI Status Bar
This bar fills from bottom to top and provides a visual reference of the
rela�onship between the applied load and the rated capacity. A warning will
occur between
92.5%
and
97.5%
of the rated capacity. This warning is an
AMBER
LED
and an audible alarm on the cab. If the applied load should exceed
104%
of
the rated capacity then the
RED LED
is lit and a con�nuous external siren is
sounded. The machine will then be inhibited to prevent further unsafe
movements.
Axle Lock Icon
Shows the current state of the axle lock. A locked padlock indicates that the axle
locked, an unlocked padlock indicates that the axles are unlocked, and an
unlocked padlock with a cross through it indicates that the axles cannot be
unlocked as it is unsafe to do so as it would put the machine into an overload
condi�on.
Cant /
Gradient
Shows the current cant and gradient of the machine (rail du�es only). Cant will
show as posi�ve (right hand rail high at 0° of slew) or nega�ve (right hand rail low
at 0° of slew), and gradient will show as posi�ve (facing up gradient) or nega�ve
(facing down gradient).
Movement
These arrows indicate the safe direc�on each piece of equipment can be moved.
GREEN
indicates movement is safe.
RED
indicates movement is unsafe.
19
Rail Gauge
Indicates the current rail gauge on use. This is set during the system installa�on
by the converter.
17