GKB HZ2001 HD-SDI PTZ Camera
22
3.4 Camera Motions
After selecting a camera, it can be moved either directly using the control panel as described
below:
!
Panning (horizontal) and tilting (vertical).
!
Zooming, focusing and IRIS opening.
!
Preset positions programming and recalling.
These functions can be directly accessed using a single key or joystick or a simple key combination.
3.4.1 Pan And Tilt
The camera may be moved using our keyboard controller. Move the joystick vertically to tilt the
camera and horizontally to pan it.
The maximum pan span is from 0º to 360º with continuous rotation. The maximum tilt span is from
-5º (camera in vertical position) and 92º.
The panning and tilting speed can be modulated by operating the joystick appropriately.
Note that the maximum speed that can be obtained by operating the joystick is not always equal
to that programmed in the working settings. This in fact depends on the value of the
PROPORTIONAL PAN
setting in the
MOTION
menu and the zoom. If the option is ON, the
maximum rotation speed which can be obtained using the joystick is proportional to the
magnification used to obtain the best frame.
Panning (horizontal)
Tip the joystick rightwards to turn the camera horizontally clockwise and tip it leftwards to turn it
anticlockwise.
If no advanced options are set (e.g. range limits set enabled), the camera can be turned
continuously without interruptions.
The pan span may be limited between two angles in
DOME SETTING1
>
MOTION
>
MANUAL
LIMIT
.
Tilting (vertical)
Tip the joystick upwards to turn the camera vertically upwards and tip it downwards to turn the
camera downwards. The camera rotation is limited upwards by the horizontal plane or
downwards by the vertical axis.
Performance will change considerably near the vertical axis according to whether the
AUTO FLIP
is
on or not (default setting is on).
!
With
AUTO FLIP
off, the camera will stop in perfectly vertical position and will stop turning
when the joystick is tipped downwards.
