GKB HZ2001 HD-SDI PTZ Camera
20
3.2 How To Use Our Control Keyboard
The camera is ready to receive commands from our control keyboard (see figure below) after
connecting.
"
Besides our control keyboard, the PTZ camera also accepts other standard control
devices with Pelco D/P or other accepted protocols.
"
This manual is based on our control keyboard. In case other control devices, please
refer to the manual of the control device for the command syntax.
3.2.1 Control Keypad Password And Access
The system will wait for the password to be entered after being switched on.
The control panel requires a 6-digit password.
The entered digits will be replaced by a “*” symbol on the screen for privacy.
Access to the menu is gained after entering all the digits correctly.
Refer to the corresponding manual for using the control panel.
"
The default user password is “000000”.
"
It is advisable to change the default password to prevent intrusions.
"
Do not lose or forget the programmed password.
"
Take note of the new password and keep it in a safe place.
3.2.2 Control Keypad Command Syntax
Controls can use the joystick, single keys or key combinations. The key command syntax is shown
below.
Key command syntax
The syntax used in this manual for controls using keys consists of various elements (words and
three digit numbers). Each command is always in braces and each element is separated by
commas. Each word or decimal digit used in the syntax is identified by a corresponding key on our
control panel. Words can be enclosed in round brackets, square brackets or no brackets. Three
digit decimals are never enclosed in brackets.
The following words only can be used:
PRESET
,
CALL
,
ESC
,
OPEN
,
CLOSE
,
NEAR
,
FAR
,
ZOOM OUT
,
ZOOM IN
,
CAM
,
MON
,
SCAN
,
ENTER
. The decimal digits are:
0
,
1
,
2
,
3
,
4
,
5
,
6
,
7
,
8
, and
9
.
