4
REAR ROTATION WASHER ASSEMBLY
✓
Depending on the type of rotation you want to obtain (clockwise-counterclockwise, 90 ° -180 °), one of the two rotation washer
supplied in the package must be installed on the back of the lock, as shown in the diagram below.
PREPARING THE LOCK FOR INITIAL PROGRAMMING
✓
The lock is supplied unlocked (open) already in the correct position for programming.
✓
We recommended you perform the mechanical lock installation before programming. For assemblies that require
programming prior to mechanical installation, contact Technical Support.
✓
We recommend you carry out the mechanical installation following this procedure: insertion in the installation location,
insertion of washer, tighten the locking ring nut and then assemble the necessary accessories such as rotation washer, cam,
flat washer and nut.
✓
Before programming the lock, be sure to align the lock as shown below.
