o
Align the device (for the position of areas A, B, C, see Aligning the device) - the brightness
sensor should, if possible, be located on the side away from the window. This reduces the
effects of scattered light.
o
For an additional flush-mounted cable entry or surface-mounted cable entry, break out the
appropriate thin point (13) (Figure 8).
o
Fastening the connection box (1) through holes (11) (Figure 8).
i
Alternatively, the device can also be mounted on a 60 mm appliance box. The screws are
not included in the scope of delivery.
Connecting the device
Figure 9: Connection diagram, single device
Figure 10: Connection diagram, parallel circuit for expanding the detection area
Max. power cable length 100 m. This takes into account all the connecting cables between the
devices and lamps.
Do not connect more than five devices in parallel.
Connect all devices to the same outer conductor.
Set all the devices to the same device function (motion detector or presence detector).
i
The connection in parallel does not increase maximum connected load.
82593212
12.01.2017
10/18
Presence detector and motion detector 360° compact
