Gira 1287 00, Руководство по эксплуатации

Страница: 24 / 40

24
Assigning door opener of a "side/back" door
The door opener connected to the switching actuator is pro-
grammed at the respective door station as follows:
1. Press the "Systemprog." button on the
control device
for
3 seconds to start programming mode (see Page 19).
2. Briefly press the "Function" button on the
switching
actuator
several times until the "Door opener" LED
flashes.
3. Press the "Prog." button on the
switching actuator
for
3 seconds until the yellow LED next to the "Prog." button
flashes.
4. Press any call button on the
door station
for 3 seconds
until you hear a short acknowledgement tone.
✓ A long acknowledgement tone confirms successful
assignment. The door opener is controlled for the set time.
To assign additional door stations to the same door opener,
repeat Step 4 at the next door station.
5. Briefly press the "Prog." button on the
switching actuator
to exit the programming mode of the switching actuator.
✓ The LED of the "Prog." button goes out. The LED of the last
selected function (here "Door opener") continues to flash
until programming mode at the control device is exited.
6. Press the "Systemprog." button on the
control device
to
exit the programming mode.
i
Releasing the button after 3 seconds
If the button press is not ended after the first acknowledge-
ment tone, all assignments of the respective door/home
station will be deleted after an additional 3 seconds.