10
UM Ovens and Incubators EN rev. 0 31.05.2021
•
Transportation of an already used oven/incubator
•
Switch off the Argolab oven/incubator by pressing the main switch.
•
Remove the power plug from the socket.
•
Remove the shelves.
•
Clean the Argolab oven/incubator and its shelves (see chapter 13 on page 18).
•
Dry the inside of the Argolab oven/incubator and the shelves.
•
Wrap the shelves with bubble wrap.
•
Pack the shelves in their original packaging and place them in the Argolab oven/incubator.
•
Pack the Argolab oven/incubator in its original packaging.
•
Take care that the Argolab oven/incubator does not get wet during transport.
•
During transport, maintain the permitted room temperature (from -10 °C to 60
°C).
6.
Conservation
•
Store the Argolab oven/incubator only in closed, dry rooms.
•
The permitted storage temperature is -10 °C to 60 °C. The maximum permitted storage humidity is 85% RH
without condensation.
7.
First installation
•
Getting started
The oven should be installed in following conditions
:
•
Dry, clean, stable worktable with a flat horizontal surface and heat resistant.
•
At least 30 cm free around the instrument.
•
Room temperature between 5 °C and 40 °C and relative humidity maximum of 85%.
•
Power supply socket with earth connection.
•
Power supply of 220/240 V - 50 Hz.
ATTENTION
Danger of overturning of the upper instrument
–
Damages to the instrument
➢
When stacking two instruments, place rubber pads under the four feet of the upper
instrument.
DANGER
Risk of explosion and death
DO NOT operate the device in potentially explosive areas.
DO NOT use explosive dust or air-soluble mixtures in the environment.
ADVICE
Risk of overheating - Damage to the instrument
DO NOT install the instrument in not ventilated area.
Ensure that there is enough ventilation to disperse heat.
Содержание ICF-120 Plus
Страница 1: ...OVENS and INCUBATORS User manual...
