GILGEN doorboy DBL-W, Руководство по сборке и эксплуатации

Страница: 12 / 31

0552-999-03_05.98.p65
2-4
25 26 28
27
34
35
Fig. 7b
5
19 14
15
16
18
17
Y
X
= =
190 - 240
Fig. 6
115
±10
20
40
X
10 10
ø10
9
12
Fig. 4
60
22
23
24
31
21
20
28
10
10
Fig. 5
2 11
Fig. 7a
z = 580
50
- At point (8), drill a hole 60 mm deep, using a drill ø10 and drive
the dowels (9) completely home. Fig. 3 and 4
- The four angles (10) are included in the delivery. Insert the tenon
blocks on both sides into the running profile and screw down the
angle (10) by means of the countersunk bolts with double nip.
Fig. 5
- Place the drive unit against the wall, with the drive head (11)
pointing upward. Lift the drive unit and securely fasten the ang-
les (10) into the dowels (9) by means of the screws (12) which are
supplied together with the drive unit. Fig. 4 and 5
- The drive unit must be adjusted in such a manner that the mea-
sures X and Y are parallel on the entire door stroke. Fig. 6
- Open the door as far as the door stop piece. Insert the driver angle
(14) into the extension arm (5). Remove the bolt (16) on the sliding
carriage (15).
- Uncouple the sliding carriage (15) by means of the red button and
move it up to the height of the driver angle (14). Couple the sliding
carriage (15) with the bolt (16) by means of the glider (17), and se-
cure the bolt (16) by means of the spring clips (18). Fig. 6
- Center the driver angle (14) in the sliding carriage (15) and tighten
the screws (19).
Options and fittings
- Manual unlocking mechanism ENTRA-W for garages without a se-
cond access.
- Control elements such as:
• Push-button
• Key-operated switch
• Additional hand-held transmitters, mini-transmitters, etc.
- Safety elements such as:
• Safety edgings EMS
• Service door contact, and others
Mounting the options
Manual unlocking mechanism ENTRA-W, Fig. 7a + 7b
Preparation: - Completely tighten the tension screw (20) on
ENTRA-W.
- insert the pressure spring (21). Insert the cable end
(22) and fasten it by means of the screw nipple (23)
Assembly: - Screw ENTRA-W onto the stop piece (31) with screw
(24).
- Lead the cable and the Bowden cable covering (28)
up to the door lock, describing large radii and ma-
king sure the door has a sufficiently free running
movement.
- Mount the angle (25) on the door by means of
screws (26) and tension screw (27).
- Replace screw (34) on the door lock.
- Pull the second cable end through the tension
screw (27) and the screw of the lock (34) and fix it
by means of the screw nipple (35).
- Tighten the tension screws (20) and (27) and secure
them with a counter-nut.
Checking: - When the door lock is actuated, the drive unit must
be uncoupled
- The door can be opened.