Page 24 MDE-5386D Hybrid Card Reader S (HCRS) Kit (M13940KXXX) Installation Instructions (Canada) · June 2020
Installing the HCRS Kit in The Advantage Series Units
2
Place the gasket over the front of the card reader making sure the gasket is seated on the flange
and covers the dismount buttons as shown in
Notes: 1) Installing this non-adhesive gasket is different from previous gasket installation. It is
laid over the card reader snout first, and then the card reader is inserted into the
card reader opening on the door. In this application, the card reader becomes your
insertion tool.
2) You can use the old gasket with the adhesive if you don’t have the non-adhesive
gasket. Remember that the gasket with the adhesive must be applied to the door first
and not the card reader.
Figure 15: HCRS in The Advantage Series Units
(i)
Front View
(ii)
Side View
Gasket
Card Reader
3
From the rear of the main door, position the HCRS and then the card reader bracket on the
front panel so that the card reader slot is positioned on the top. Loosely secure the card reader
bracket and HCRS to the main door using the four screws provided in the kit, in the four holes
(looking from the back of the HCRS).
Note: When installing the card reader bracket onto the HCRS, the lip on the bottom of the
card reader bracket must face toward you (toward the data/power connector).
4
Align the HCRS and card reader bracket. Securely tighten the four mounting screws in stages
in a diagonal pattern to ensure correct seating of the card reader.
Do not overtighten the screws. Overtightening of the screws can strip or break the card reader
bosses.
The following are the torque settings for the different door types:
• Non-threaded insert doors: 18 +/-2 inch-lbs
• Threaded insert doors: 12 inch-lbs
