GILBARCO VEEDER-ROOT M13940K Series, Руководство по установке

Страница: 32 / 42

Page 32 MDE-5386D Hybrid Card Reader S (HCRS) Kit (M13940KXXX) Installation Instructions (Canada) · June 2020
Installing HCRS Kit in Husky OPT Units
7
Remove the card reader gasket. Use a putty knife, if required. Ensure that you have a smooth
clean surface before applying the new card reader gasket.
Figure 25: TCR on Husky OPT
Nut securing the Card Reader Bracket (other two nuts on the right side of the bracket is not shown)
Screw securing the Activation Switch
Card Reader Bracket
Card Reader (TCR)
Installing the HCRS
To install the HCRS in Husky OPT units, proceed as follows:
A properly grounded ESD wrist strap must be worn while servicing any electronic
devices or components. Failure to use electrostatic precautions may damage
electronic components and void warranty.
CAUTION
1
Obtain the HCRS, card reader bracket, and gasket (see Figure 4 on page 11 ) from the kit.
Note: Do not remove the foam block from the connector until after installation is complete.
This is to protect the connector pins from damage during installation.