GILBARCO VEEDER-ROOT M13940K Series, Руководство по установке

Страница: 15 / 42

MDE-5386D Hybrid Card Reader S (HCRS) Kit (M13940KXXX) Installation Instructions (Canada) · June 2020 Page 15
Installing HCRS Kit in Encore S E-CIM Units
6
Remove the four hexagonal-head screws that secure the card reader bracket and card reader to
the option door using a 1/4-inch nut driver or ratchet and socket (see
Figure 7 ). Remove and
discard the card reader and card reader bracket.
Figure 7: Top View of TCR
Screws on the Card Reader Bracket
Data/Power Cable Connection
Card Reader (TCR)
Card Reader Bracket
ESD Ground Cable
7
Remove the old card reader gasket from the option door. Use a putty knife, if required.
Removing the existing card reader is now complete.
Installing HCRS
To install the HCRS in Encore S E-CIM units, proceed as follows:
A properly grounded ESD wrist strap must be worn while servicing any electronic
devices or components. Failure to use electrostatic precautions may damage
electronic components and void warranty.
CAUTION
1
Obtain the HCRS, card reader bracket, and gasket (see Figure 11 on page 18 ) from the kit.
Note: Do not remove the foam block from the connector until after installation is complete.
This is to protect the connector pins from damage during installation.