MDE-5386D Hybrid Card Reader S (HCRS) Kit (M13940KXXX) Installation Instructions (Canada) · June 2020
Page 23
Installing the HCRS Kit in The Advantage Series Units
10
Remove the four hexagonal-head screws that secure the card reader bracket and card reader to
the option door using a 1/4-inch nut driver or ratchet and socket. Remove and discard the card
reader and card reader bracket.
Figure 14: Top View of TCR
Data/Power Cable Connection
Card Reader (TCR)
Card Reader Bracket
Screws on the Card Reader Bracket
ESD Ground Cable
11
Remove the old card reader gasket from the option door. Use a putty knife, if required.
Removing the existing card reader (TCR) is now complete.
Installing HCRS
To install the HCRS in The Advantage Series units, proceed as follows:
A properly grounded ESD wrist strap must be worn while servicing any electronic
devices or components. Failure to use electrostatic precautions may damage
electronic components and void warranty.
CAUTION
1
Obtain the HCRS, card reader bracket, and gasket from the kit.
Note: Do not remove the foam block from the connector until after installation is complete.
This is to protect the connector pins from damage during installation.
