Gigglepin GP25, Руководство пользователя

Страница: 7 / 30

The GP25 has 18 symmetrical M12 mounting bolts giving it superior winch security in the
toughest of situations. When fitting your GP25 winch a minimum of six retaining bolts on one
face must be used at all times.
Note - The four missing mounting bolts and washers from the front of your winch are used
to secure the winch to the shipping pallet.
If possible Gigglepin recommend using two of the three mounting faces to hold the winch
securely, and using twelve mounting bolts where possible. Gigglepin recommend the use of
winch mounts made from a minimum of 8mm steel plate. Rear mounting bolts should not go
into the casing more then 20mm.
Gigglepin DO NOT recommend the use of tubular style winch mounts or wide mouth fairleads.
Your GP25 arrives fitted with two aluminium BraceBars to the rear of the winch. We recommend
that the BraceBars are retained where possible, unless the rear mounting points are to be used.
The GP25 is best mounted standing upright. However it can be mounted at various different
angles, but we recommend this must not be less than 20 degrees from horizontal, so as not to
affect gearbox operation and to prevent oil pooling in the TopHousing.
The Winch can also be mounted in a reverse position, but care must be taken to install the
Fairlead and rope in the correct position.
Caution - We do NOT recommend the winch is mounted laid flat.
Warning - Please remember that winch mounts need to be strong and securely fastened to
the vehicle or platform. Weak or bent mounts could result in equipment failure and
possible personal injury.
Fitting your Fairlead
You must fit the Fairlead to the correct location dependant on how your winch is installed.
With the winch in the upright (Section 7, Page 25) position, the FairLead needs to be fitted to
the lower front mounting points. If using the winch in a reverse position, the FairLead would
need to be mounted at the top (Section 7, Page 25).
It is also very important that the 3x M8 support bolts are used (Not used on short drums).
These can be fitted in two ways -
- Drill and tap your winch mounting plate, then trim the bolt to the correct length so it does
not interfere with winch rope. Note - This is our recommended method.
- Drill a hole through your winch mount and use the nuts and bolts supplied.
After fitting your FairLead, make sure there are no sharp edges on the mount that might
damage your winch rope.
2
A GP25 winch is designed to move a load at ground level or up or down an incline. It is not
designed for, nor intended for hoisting.
A GP25 winch is not designed to be used to lift or move people.
A GP25 winch is for intermittent use and is not designed for continuous use.
If the winch motors become hot, allow the winch motors to cool before continuing to winch.
If the winch stalls during operation, stop pulling! DO NOT continue to apply power to the
winch. This can damage your winch and your electrical system.
Re-evaluate the rigging, check for obstruction and double-line if required.
2. Application Information
b. How do I fit my GP25