14
launch.
Note
:
a. GS1100 will be automatically turned off if there is not any communication between
PC and the terminal over 3 minutes. This is for power saving purpose.
b. To prevent unwanted people from using GuardScan Monitor program, make sure
the program is ended when leaving PC.
c. Make sure all the data is downloaded before executing the Clear Data command.
If GuardScan Monitor cannot work properly with GS1100, please check it up
according to following procedures:
Check if GS1100 is equipped with the battery.
Check if GS1100 is connected with the communication cable correctly and
the cable is connected to the COM port of PC correctly.
Check if the Green SCAN LED of GS1100 keeps blinking.
Check if the
“Comm. Port” selection in GuardScan Monitor is correct.
After you have done all procedures as above, restart your GuardScan Monitor to
check if it runs well. If not, please contact your local distributor for technical support.
